The energy a residential well system uses depends on the equipment and your water use. Unlike a public water supply, the homeowner is responsible for maintaining the well, ensuring drinking water is safe and paying for the electricity needed to run the well pump. Here are steps to improve and maintain your residential well and use less power.
Get an Inspection
If you’re concerned about how much you pay to pump water from your well, start with an inspection. Well pumps are put to work daily, and parts wear over time. Regular maintenance can improve efficiency and the life span of the system.
Proper system design and sizing can save energy. Oversized equipment wastes energy. Ask a professional if your well equipment is properly sized for your needs. In some cases, adding a variable-speed drive can save energy.
Keep in mind, well systems don’t last forever. Consider design and sizing before the existing system fails.
A well inspection may locate issues that are hard to spot. The system may even act normally with good water pressure and flow while using more energy and causing higher bills. The likely culprit is an underground leak between the pump and the home. Even if your well is in good working order, there are practices you can implement to save on your electric bill.
Lower Your Water Use
The less water you use, the less energy you use. Here’s how you can conserve water and electricity with your home appliances.
Toilets. Check your toilet for leaks by putting a few drops of food coloring in the tank. If the color appears in the bowl without flushing, your toilet is leaking. This is likely caused by a worn flapper, which is an inexpensive and easy do-it-yourself fix.
If your toilets were installed before 1994, they’re likely using more than 4 gallons per flush, which is well above new energy standards of 1.6 gallons. The average family can save nearly 13,000 gallons per year by replacing old, inefficient toilets with models certified by WaterSense.
Another option is the tried-and-true plastic bottle method. Place sand or pebbles into a 1- or 2-liter bottle and place it in your toilet tank. This results in less water filling the tank and less water being flushed.
Dishwasher. If you wash dishes by hand, start using your dishwasher instead. Did you know new Energy Star-certified dishwashers use less than half the energy it takes to wash dishes by hand? According to the Department of Energy, this simple change in habit can save more than 8,000 gallons of water each year.
Washing machine. Run your machine only with full loads to save water and energy. You may also consider upgrading to an Energy Star-certified washing machine, which uses about 20% less energy and about 30% less water than regular washers.
Showerheads and faucets. Fix leaky showerheads and faucets. According to the Environmental Protection Agency, a leaky faucet that drips at the rate of one drip per second can waste more than 3,000 gallons of water per year. Aerators are inexpensive devices that reduce water flow. Look for faucet aerators with no more than 1 gallon per minute flow rates and low-flow showerhead rates of less than 2 GPM.